Find your EnGenius Service 1300 725 323
 
ENS202
Wireless-N 300Mbps Long Range Outdoor AP/CB
05-02-2013 Rev:17-02-2014

How to do config WDS Bridge Mode

The diagram above shows four Engenius devices running on WDS Bridge Mode, which are connected
to a main Engenius devices that is providing Internet access. These 5 devices will run on WDS Bridge Mode.
This is a bridged network; therefore, all nodes on the network can be in the same network IP
block. All computers are viewable as if they are in the same location and on the same Ethernet
network.

Step1.

1.  Select System > Operation Mode

2.  Select WDS Bridge

3.  Click the Save & Apply button

 

Step2.

1.  Select Wireless > WDS Link Settings

2.  Select encryption mode and fill in with passphrase

3.  Select Enable mode

4.  Enter the desired AP MAC addresses

5.  Click the Accept button

 

 

Step3.

1.  Select Wireless Network

2.  Confirm the channel

3.  Click the Accept button

 

Step4

1.  Repeat Step1 to 3 on the other WDS AP

2.  Confirm the WDS Link Status


More Support Topic
- ZoneController3.8.1 quick guide 13-07-2015 Read
- How to do config WDS Bridge Mode 17-02-2014 Read
- How to config as Client Bridge. 17-02-2014 Read
- WDS Bridge Mode Setting (Details) 07-10-2014 Read
- WDS Bridge Setting 19-02-2014 Read
Talk to us to find out more support information on 1300 725 323.
Copyright © 2011 EnGenius Data Communication Australia | Privacy Policy